View Single Post
Old 04-24-2010, 05:59 AM   #28
Rolling Thunder Tech
Company Commander
 
Rolling Thunder Tech's Avatar
 
Join Date: Jun 2005
Location: Bay Area, California
Posts: 744


Started to work on the track guides, and there are a LOT of them. Broke them off the sheet metal plate and cut off the little nubs. There is to be a track guide tool included in the kit, which is used to bend all of the guides to the proper angle. Unfortunately, the one in this kit is missing, so I'm bending them using needle nose pliers.

The track guides are then screwed in place to the rubber track. WIll add photos when I get that far.

[img][/img]

The rubber track material is very nice, and is about 3/8 inch thick at the thickest part.
[img][/img]

Leonard
RTT
Rolling Thunder Tech is offline   Reply With Quote